Using EurekaLog inside a Runtime/designetime BPL

[EduardoGomes]

Hi,

I just wanna know if this is supported.
I have enabled eurekalog when I compile my package, but it never gets any exceptions raised.... is this possible?

I´m using version 5.0.6.

Thanks!

[admin]

Hi,

EduardoGomes wrote:
> Hi,
>
> I just wanna know if this is supported.
> I have enabled eurekalog when I compile my package, but it never gets
> any exceptions raised.... is this possible?
>
> I´m using version 5.0.6.
>
> Thanks!

For the Design-Time packages you must install it on an IDE with
EurekaLog installed.

For the Run-Time packages you can use it on an application compiled with
EurekaLog.

--
Best regards...

Fabio Dell'Aria.
----------------
http://www.eurekalog.com
Catch every BUG, every time!

[EduardoGomes]

Fábio,

Uhm... ok, but what if I don´t compiled it all in the exe? I mean, what if I use build with runtime packages? :confused:

Does it work the same way? Because I can´t seem to make it work...

Thanks!

[admin]

Hi,

EduardoGomes wrote:
> Fábio,
>
> Uhm... ok, but what if I don´t compiled it all in the exe? I mean, what
> if I use build with runtime packages? :confused:
>
> Does it work the same way? Because I can´t seem to make it work...
>
> Thanks!

All the Run-Time packages compiled with EurekaLog works both with
application compiled with and without EurekaLog.

All the Run-Time packages compiled without EurekaLog works both with
application compiled with and without EurekaLog.

I hope to have answered to your question now! :)

--
Best regards...

Fabio Dell'Aria.
----------------
http://www.eurekalog.com
Catch every BUG, every time!